`1` ```exercism fetch ruby two-bucket ```

# Two Bucket

Given two buckets of different size, demonstrate how to measure an exact number of liters by strategically transferring liters of fluid between the buckets.

Since this mathematical problem is fairly subject to interpretation / individual approach, the tests have been written specifically to expect one overarching solution.

To help, the tests provide you with which bucket to fill first. That means, when starting with the larger bucket full, you are NOT allowed at any point to have the smaller bucket full and the larger bucket empty (aka, the opposite starting point); that would defeat the purpose of comparing both approaches!

Your program will take as input:

• the size of bucket one
• the size of bucket two
• the desired number of liters to reach
• which bucket to fill first, either bucket one or bucket two

• the total number of "moves" it should take to reach the desired number of liters, including the first fill
• which bucket should end up with the desired number of liters (let's say this is bucket A) - either bucket one or bucket two
• how many liters are left in the other bucket (bucket B)

Note: any time a change is made to either or both buckets counts as one (1) move.

Example: Bucket one can hold up to 7 liters, and bucket two can hold up to 11 liters. Let's say bucket one, at a given step, is holding 7 liters, and bucket two is holding 8 liters (7,8). If you empty bucket one and make no change to bucket two, leaving you with 0 liters and 8 liters respectively (0,8), that counts as one "move". Instead, if you had poured from bucket one into bucket two until bucket two was full, leaving you with 4 liters in bucket one and 11 liters in bucket two (4,11), that would count as only one "move" as well.

To conclude, the only valid moves are:

• pouring from one bucket to another
• emptying one bucket and doing nothing to the other
• filling one bucket and doing nothing to the other

Written with <3 at Fullstack Academy by Lindsay.

For installation and learning resources, refer to the exercism help page.

For running the tests provided, you will need the Minitest gem. Open a terminal window and run the following command to install minitest:

 `1` ```gem install minitest ```

If you would like color output, you can `require 'minitest/pride'` in the test file, or note the alternative instruction, below, for running the test file.

Run the tests from the exercise directory using the following command:

 `1` ```ruby two_bucket_test.rb ```

To include color from the command line:

 `1` ```ruby -r minitest/pride two_bucket_test.rb ```

## Source

Water Pouring Problem http://demonstrations.wolfram.com/WaterPouringProblem/

## Submitting Incomplete Solutions

It's possible to submit an incomplete solution so you can see how others have completed the exercise.